Vornado SRTH Spécifications télécharger pdf (Page 10)

10 English



In smaller areas, you might prefer to set the mode switch to LOW.



In larger spaces, your Vornado® Small Room Tower Heater will function

most effectively with the MODE switch set to HIGH. In the HIGH position, the

ﬂow of air will gently keep the air circulating in the room for even, uniform

heating.



Your SRTH can function as a personal fan for cooling.



Your SRTH draws up to 7.5 amps of electric current. If using your SRTH on

HIGH HEAT causes your home’s circuit breaker or fuse to trip, we offer the

following suggestions:

• Try turning off other electrical appliances that run on the same circuit as

your SRTH.

• Run your heater on LOW HEAT.

• Have your electrician add an additional circuit to your home’s electrical

system.



ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR ANY

ELECTRICAL APPLIANCE.

Operating Tips

Troubleshooting

Unit is not plugged in. Plug Power Cord into electrical outlet.

Tip-over switch is not making contact with the ﬂoor. Place heater on a level surface to ensure tip-over switch is making full

contact with the ﬂoor.

Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault inter-

rupter, or replace fuse (See OPERATING TIPS below).

The unit has overheated. Automatic Safety Shut-Off has been initiated (See RESETTING YOUR VORNADO HEATER on page 8).

Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.

Ensure unit is set to highest Temperature setting.

Close all doors and windows to retain heat.

Allow the unit to fully distribute the heat throughout the room, this may take several minutes.

Unit fails to

power on.

Unit is not pro-

ducing sufﬁcient

amount of heat.

Problem Possible Cause and Solution

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Vornado SRTH Spécifications Page 10