Vornado SRTH Spécifications télécharger pdf (Page 10)

10 English

Troubleshooting

Unit is not plugged in. Plug Power Cord into electrical outlet.

Tip-over switch is not making contact with the ﬂoor. Place heater on a level surface to ensure tip-over switch is mak-

ing full contact with the ﬂoor.

Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault

interrupter, or replace fuse (See OPERATING TIPS below).

The unit has overheated. Automatic Safety Shut-Off has been initiated (See RESETTING YOUR VORNADO HEATER on

page 8).

Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.

Ensure unit is set to highest Temperature setting.

Close all doors and windows to retain heat.

Allow the unit to fully distribute the heat throughout the room, this may take several minutes.

Power off and unplug the unit. On the bottom of the unit, there is a black disk. Push in 4-5 times ensuring it is not

stuck. Set unit down on ﬂat surface. Be sure power cord is not under unit. Plug unit in and power on. Turn to high-

est heat setting.

Unit fails to

power on.

Unit is not pro-

ducing sufﬁcient

amount of heat.

Unit power on but

there is no heat.

Problem Possible Cause and Solution

1 2 ... 5 6 7 8 9 10 11 12 13

Pas de commentaire

Vornado SRTH Spécifications Page 10